Installation Instructions
Specifications are subject to change without notice
Page 6
[email protected] | www.manrose.co.nz
Distributed by Simx Limited
Inline Extraction Fan Kit - 125mm Standard Profile
Timer Adjustment only
This time delay can be adjusted by firstly switching off the power to the fan and removing the cover on the bracket. Locate the rotary adjuster as
shown in (Fig 4). The serrated adjuster wheel can be rotated using a thumbnail to adjust the timer setting.
+ = Rotate to the right to increase the time (indicated by + on the diagram)
- = Rotate to the left to decrease the time (indicated by - on the diagram)
Only adjust with power switched off.
All wiring must be fixed securely and the cable to the fan should be a minimum of 1mm
2
in
section. All wiring must comply with current regulations. This system should be installed by a registered electrician. These units
are double insulated and therefore do not require an earth.
INSTALLATION
PUB0330 2208
Flexible duct
Internal diffuser
External grille
The inline extraction fan
screwed to the joist
TYPICAL INSTALLATION
Recommended
mounting position
