Diagram 2
Diagram 2A
We reserve the right to change specifi cation without prior warning
Manrose is proudly distributed by Simx Limited
PO Box 14 347, Panmure, Auckland, NZ. Technical Support (09) 259 1662
e: [email protected] | www.simx.co.nz | www.manrose.com.au
(The ‘new’ ball bearing designed motors provide an extended lifetime of operation)
NOTE: (i) The fan is to be installed so that the blades are 2.1m above the fl oor. For best results
this Extractor Fan should be fi tted as high on the wall as possible, or if preferred, on
the
ceiling.
(ii) Do not install the unit within a shower cubicle. Use our shower fan models no’s
SF125S or SF125T.
(iii) Switch off mains supply before making electrical connections. This system should
be installed by a qualifi ed electrician.
(iv) This fan is double insulated and does not require an earth.
(v) When installing fan through an external wall, an external wall grille must be fi tted
at all times.
1.
Cut a 140mm diameter hole in the wall. If the fan is to be fi xed onto the ceiling ensure that
the hole is between the joists.
2.
Fit 125mm ducting fl ush to the plaster.
3.
Remove the cover from the fan by simply unclipping the fascia. The front cover screw and
plug are conveniently located within the fan housing as shown in diagram 1 & 2.
4.
Hold the body of the fan against the wall or ceiling and mark the four screw holes and the
cable entry.
IMPORTANT: Ensure that the fan is square on wall the or ceiling.
5.
Bring power cable into position, as marked. Allow an extra 230mm (9”) protruding to
facilitate connection.
Fan should only be installed by fi xed wiring, a fl exible cord should not be used.
6.
If an XP125 kit - Select a suitable position on the outside wall for the weatherproof cowl.
Carefully remove the cowl from its housing by levering gently at the sides with a small
screwdriver. Cut a 140mm hole ensuring fi rst that the area is free from obstruction.
7.
Wiring of Standard Model XF125S and XP125S (see Diagram 2A).
(For remote switch operation).
The fan can be connected to the light switch so that the fan will start when the light is switched
on. The fan should not be accessible to a person using either the shower or the bath.
NOTE:
All wiring must be fi xed securely and the cable to the fan should be a minimum of
1mm
2
in section. All wiring must comply with current Regulations. This system should be
installed by a qualifi ed electrician.
Pub7007 Iss06 11/17
MANROSE CLASSIC XF/XP125 CEILING/WALL
EXTRACTOR FANS
INSTALLATION INSTRUCTIONS
C L A S S I C S E R I E S
Rotary adjuster
for time delay
Diagram 2B
