Mannesmann ecodrive03, Руководство по устранению неисправностей, Страница: 117 / 128

ECODRIVE03 SMT-02VRS Index
7-1
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
7 Index
+
+24Volt DC error 3-22
5
5 pulses found, but min. distance to move not reached 4-3
A
Ab 4-42
Absolute encoder out of allowed window 3-14
Absolute measuring system not installed 4-18
AC 4-42
Acceleration data scaling error 4-13
AE 4-42
AF 4-42
AH 4-42
Amplifier overtemp. shutdown 3-3
Automatic drive check and adjustment 4-39
B
Basic load 4-20
bb 4-42
Bleeder overload prewarning 3-29
Bleeder overload shutdown 3-4
Brake check command 4-3
Brake check only with drive enable 4-3
Brake torque too low 3-33, 4-4
C
Cancel reference point procedure command 4-27
Command adjust commutation 4-23
Command automatic loop tuning 4-28
Command Current limit active 3-32
Command current limit shutoff 3-12
Command Get mark position 4-26
Command not enabled 4-3
Command Release motor holding brake 4-3
Command Set absolute measuring 4-17
Command velocity limit active 3-32
Communication phase 0 4-31
Communication phase 1 4-31
Communication phase 2 4-31
Communication phase 3 4-32
Communication phase 3 transition check 4-4
Communication phase 4 transition check 4-10
Commutation offset could not be determined 3-20
Commutation offset could not be determined. 4-25
Config. IDN for AT not configurable 4-6
Config. IDN for MDT not configurable 4-5
Configurated length > max. length for AT 4-6
Configurated length > max. length for MDT 4-6
Continuous current limit active 3-31
Continuous current limit prewarning 3-32
Control and power sections ready for operation 4-33
Current measurement trim wrong 3-14
D
Default parameter load 4-21
Default parameters invalid 4-21