Maintenance
Section 4
4-4
G. Remove the ice damper.
•
Grasp ice damper and apply pressure toward the left
hand mounting bracket.
•
Apply pressure to the right hand mounting bracket
with thumb.
•
Pull ice damper forward when the right hand ice
damper pin disengages.
Installation
•
Place ice damper pin in left hand mounting bracket
and apply pressure toward the left hand mounting
bracket.
•
Apply pressure to the right hand mounting bracket
with thumb.
•
Push ice damper toward evaporator until right hand
damper pin engages.
H. Remove the Bin Door
•
Grasp the rear of the bin door and pull bin door
forward approximately 5”.
•
Slide bin door to the rear while applying upward
pressure (The rear door pins will ride up into the track
slot and slide backward to the stop tab).
•
While applying pressure against the bin door pull
down on the rear of each bin door track until the door
pins clear the stop tabs.
•
Slide the rear door pins off the end and then below
the door track. Slide bin door forward allowing the
back of the door to lower into the bin. Continue
forward with the bin door until the front pins bottom
out in the track.
•
Lift right side of door until the front pins clear the
track, then remove door from bin.
TRACK SLOT
SLIDE DOOR
FORWARD
STOP TAB
PRESS DOWN
TO RELEASE
DOOR
