Manitowoc S160 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 28

Part Number 000007646 Rev 02 5/20 23
Checklist
If a problem arises during operation of your dispenser,
follow the checklists below, before calling service. Routine
adjustments and maintenance procedures are not covered
by the warranty.
n
Warning
Unplug unit before servicing or cleaning. Ice dispenser bin
contains parts that can move at any time and will cause
injury if hands are in the way.
PROBLEM: ICE DOES NOT DISPENSE WHEN ROCKING CHUTE IS DEPRESSED
Problem Possible Cause To Correct
Dispenser does not operate. No electrical power to dispenser. Plugged in?
Breaker tripped?
Check the cord and plug of the dispenser.
Replace cord set if wire is broken.
Dispenser runs but does not dispense ice. No ice in bin. Add ice to bin, have ice machine checked.
PROBLEM: DISPENSER CRUSHES ICE AS IT DISPENSES
Problem Possible Cause To Correct
Dispenser crushes ice as it dispenses. The ice in the bin is not the proper size and
type.
Replace with acceptable ice.
Is the ice being used a full size piece of ice,
i.e., are cubes full, not shallow, etc.?
Adjust ice machine cube size. Refer to ice
machine Installation, Use and Care manual
for procedure.
PROBLEM: ICE CONTINUES TO DISPENSE OR DISPENSES BY ITSELF
Problem Possible Cause To Correct
Dispenser agitates every 55 seconds. No jumper on the timer. Call for Service.
Does ice continue to dispense after the cup
has been pulled away?
Does the gearmotor continue to run during
this time?
Call for Service.
Does the ice dispense by itself without
anyone around the dispenser?
Does the dispenser do this at regular
intervals?
Call for Service.
Section 5
Troubleshooting