Manitowoc S160 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 28

14 Part Number 000007646 Rev 02 5/20
Operation Section 3
Room Key Card Activation
1. User places ice bucket under ice chute.
2. User places their hotel room key card into a slot on the
dispenser which is labeled “Insert Room Key Card”. The
room key activates the microswitch.
3. The user then presses the Rocking Chute (Push for Ice)
for ice dispense. Pushing the ice chute activates the
gearmotor.
The room key card must stay in the slot for the microswitch
to remain activated.
Coin Operated Activation
1. User places ice bucket under ice chute.
2. User places one quarter (U.S. currency only) into
dispenser.
3. The user then presses the Rocking Chute (Push for Ice)
for ice dispense.
Pushing the ice chute activates the gearmotor. Ice will
dispense for up to one minute for each 25 cent activation per
factory setting.
Notice
Coin Operated Activation will accept U.S. quarters only.
No other coin is accepted and no change is returned to the
user. To allow use of Canadian coins refer to instructions
in this manual.
Adjustments
ADJUSTING THE COIN MECHANISM TIMER
1. Remove the control box cover. On the inside of the
control box there is a white instruction label which
shows how to set intervals for coin mechanism dispense
times.
2. Inside the control box, the coin mechanism timer is to
the left. The ice agitation timer is to the right.
3. With a small Phillips head screwdriver, adjust the coin
mechanism timer. For timer adjustment reference
information, see below or refer to the white instruction
label inside the control box cover.
4. The timer is factory set at the midpoint for 60 seconds
of dispense time. The adjustment pot can be set
(counterclockwise) for as low as 12 seconds of dispense
time. The adjustment pot can be set (clockwise) for as
high as 120 seconds of dispense time.
ADJUSTING THE COIN MECHANISM FOR CANADIAN
COINS
Notice
Canadian quarters are magnetic. Therefore the magnet
inside the coin mechanism must be removed so Canadian
quarters will drop through the coin mechanism.
1. Remove the front panel of the dispenser. The coin
mechanism can be changed while in place in the
dispenser door, as shown above.
2. Pivot the coin magnet housing section away from the
rest of the coin mechanism.
3. Using a small screwdriver, loosen the set screw which
holds an aluminum plate in the coin magnet housing.
4. Remove the aluminum plate.
5. Using a metal screwdriver tip, pull out the magnet from
the magnet housing. (The back side of the magnet has
the stronger magnetic attraction.)
6. The aluminum plate and magnet have now been
removed from the coin magnet housing. Pivot the empty
coin magnet housing section back into place.
7. Reinstall the front door of the dispenser.