Manitowoc Q210 series, Руководство техника

Страница: 68 / 236

68 Part Number 80-01111-9 7/10
4. Wait until the Clean light flashes (3 minutes) then
add 3 oz of Manitowoc cleaner by lifting the water
shutter and pouring directly into the spray area.
The ice machine will automatically time out a ten
minute cleaning cycle, followed by eight rinse
cycles, and stop. The Clean light will turn off to
indicate the Clean cycle is complete. This entire
cycle lasts approximately 30 minutes.
5. When the cleaning process stops, remove all
parts as described in Removal of Parts for
Cleaning and Sanitizing.
6. Mix 16 oz (480 ml) cleaner with 1 gal (4 L) of
warm water in a non metallic container.-
7. Take all components to sink for cleaning. Use 1/2
of the Cleaner/Water mixture and clean all
components with a soft nylon brush or cloth.
Disassemble spray bar, remove nozzles and
inserts and soak for 5 minutes. For heavily scaled
parts, soak in solution for 15 – 20 minutes. Rinse
all components with clean water.
8. While components are soaking, use nylon brush
or cloth to clean inside of ice bin. Clean inside of
door, door gasket, bin, top of evaporator and
evaporator bucket. Rinse all areas thoroughly with
clean water.
SANITIZING PROCEDURE
Use sanitizer to remove algae or slime. Do not use it to
remove lime scale or other mineral deposits.
NOTE: Always perform a cleaning procedure before
sanitizing the ice machine.
1. Mix 4 oz (120 ml) sanitizer with 6 gal (13 L) of
warm water in a non metallic container.
2. Take all components to sink for sanitizing. Use the
Sanitizer/Water mixture and sanitize all
components that were removed for the Cleaning
Procedure with a soft nylon brush or cloth. Soak
for 5 minutes. Do not rinse sanitized components.