Manitowoc National Crane 600E-2, Руководство оператора

Страница: 16 / 122

SAFETY PRECAUTIONS OPERATOR MANUAL 600E2
2-4
PUBLISHED 04-26-2019 CONTROL # 113-09
Know the weight of all loads and always check the capacity
of the equipment as shown on the
Load Chart before making
any lifts.
NEVER exceed the rated capacity shown on the Load Chart .
Always check the Load Chart to ensure the load to be lifted
at the desired radius is within the rated capacity of the
equipment.
For detailed information concerning the operation and
maintenance of the RCL system installed on the equipment,
see the RCL manufacturer’s manual supplied with the
equipment. Manufacturers of rated capacity limiters may
refer to them in their manuals as a load moment indicator
(LMI), a hydraulic capacity alert system (HCAS); National
Crane refers to these systems as a rated capacity limiter
(RCL) throughout its
Operator and Service Manuals .
Anti-Two-Blocking Device
This equipment should have a functional Anti-Two-Block and
Control Lock-Out System. Test daily for proper operation.
Two-blocking occurs when the load block (hook block,
headache ball, rigging, etc.) comes into physical contact with
the boom (boom nose, sheaves, jib, etc.). Two-blocking can
cause hoist lines (wire rope), rigging, reeving, and other
components to become highly stressed and overloaded in
which case the rope may fail allowing the load, block, etc. to
free fall.
Two-blocking is more likely to occur when both the main and
auxiliary hoist lines are reeved over the main boom nose and
jib nose respectively. An operator, concentrating on the
specific line being used, may telescope or lower the boom
allowing the other hoist line attachment to contact the boom
or jib nose, thus causing damage to the sheaves, or causing
the rope to fail, dropping the lifting device to the ground and
possibly injuring personnel working below.
Caution must be used when lowering the boom, extending
the boom or hoisting up. Let out load line(s) simultaneously
to prevent two-blocking the boom tip(s) and the hook block,
etc. The closer the load is carried to the boom nose the more
important it becomes to simultaneously let out hoist rope as
the boom is lowered. Keep load handling devices a minimum
of 107 cm (42 in) below the boom nose at all times.
Two-blocking can be prevented. Operator awareness of the
hazards of two-blocking is the most important factor in
preventing this condition. An Anti-Two-Block System is
intended to assist the operator in preventing dangerous two-
block conditions. It is not a replacement for operator
awareness and competence.
Never interfere with the proper functioning of operational
aids or warning devices.
Working Area Limiter (If Equipped)
This equipment may be equipped with a working area limiter
as part of the RCL system, designated as either Work Area
Definition System (WADS) or Working Range Limiter (WRL).
You must read and understand the operator manual before
operating the working area limiter system. Become familiar
with all proper operating procedures and with the
identification of symbol usage.
The working area limiter is intended to be used as an aid to
the operator. It is not a substitute for safe equipment
operating practices, experience, and good operator
judgments.
EQUIPMENT STABILITY/STRUCTURAL
STRENGTH
To avoid death or serious injury, ensure that the equipment is
on a firm surface with load and equipment’s configuration
within capacity as shown on the equipment’s
Load Chart and
notes.
Ensure all pins and floats are properly installed and outrigger
beams are properly extended before lifting on outriggers. On
models equipped with outriggers that can be pinned at the
mid-extend position (vertical stripe, if applicable), the
outriggers must also be pinned when operating from the mid-
extend position.
Use adequate cribbing under outrigger floats to distribute
weight over a greater area. Check frequently for settling.
9250 Example decal. For reference only.
Fo
r
Reference
Only