Section 2
Installation
2-3
Leveling the Cabinet
The cabinet must be leveled after it is positioned in
its permanent location. This insures proper door
alignment on all cabinets, and adequate condensate
water drainage and proper refrigeration system
operation.
Leveling the Cabinet
CAUTION
If casters are installed instead of legs, the floor must
be leveled before final positioning of the cabinet.
1.
Place a level on top of the cabinet.
2.
Turn the leveling foot of the lowest corner leg to
center the bubble in the level.
3.
Adjust each of the other corners until the bubble
is centered and the cabinet is stable.
4.
Re-check the cabinet from side to side and from
front to rear with the level. Adjust the leg levelers
as necessary.
Shelf/Tray Slide Installation
SHELVES
1.
Determine the desired shelf location.
NOTE: The shelves may be located at any position in
1" increments. Optimum spacing is one shelf near the
bottom of the cabinet, one shelf near center height,
and one shelf at eye level (Refer to drawing).
2.
Install four clips per shelf, one at each corner. The
shelf clips slip into the 3/8" holes and slide down.
3.
Make sure that the clips are level from side to
side and from front to rear at each corner.
4.
Install the shelves with the smaller wires running
from front to back.
Shelf Installation
TRAY SLIDES
Tray slides are optional accessories and must be
ordered separately. To install a tray slide:
1.
Locate the appropriate square shelf standard holes
at the desired height.
2.
Insert the tabs of each slide into the 3/8" holes in
the shelf support standards and pull it straight
down to lock it into place (Refer to drawing
below).
Tray Slide Installation
SER.3
SHELF
SUPPORT
STANDARD
SER.2
SHELF
CLIP
TRAY
SLIDE
SHELF
SUPPORT
STANDARD
NOTE: SHELF SUPPORT
STANDARDS ARE
SHOWN OUTSIDE
FOR CLARITY
