Section 3
Start-Up
3-1
Section 3
Start Up
Electrical Requirements
All cord-connected units should be plugged into a
grounded and properly sized electrical outlet with
appropriate overcurrent protection. Refer to the
drawing below for electrical plug configurations.
5-20P and 5-15P Electrical Plug Configurations
All permanently connected (hard-wired) units are
fitted with a power junction box and 6” pigtail wires
for power connection.
Connect one end of the power line to the pigtail from
the cabinet junction box. Connect the other end to a
properly sized electrical source.
As a rule, the power lines must be enclosed inside a
conduit secured to the power junction boxes on both
ends.
CAUTION
Power installation must be in compliance with the
National Electrical Code and all applicable local
and state codes.
WARNING
Never use an extension cord.
Never alter the power cord or plug supplied with
the cabinet.
After the power source has been connected, turn on
the main power switch. The switch is located on the
cabinet top, behind the front panel.
SER.4
5-20P
5-15P
