Manitowoc 16000WA, Руководство оператора

Страница: 74 / 110

Reference
Only
SET-UP AND INSTALLATION 16000 WIND ATTACHMENT OPERATOR’S MANUAL
4-44
Published 03-18-13, Control # 116-09
4. Remove pins (21, View B) to disconnect links (20) from
the boom cap.
5. Pin links (20, View A) to the extended upper boom point
with pins (21).
6. Place the extended upper boom point on a trailer for
shipping or on blocking for storage.
7. Disconnect the lifting slings.
8. Unpin storage links (16, View F).
9. Remove pins (19, View F).
10. Rotate links (15, View F) forward and secure them to the
boom cap (View E).
11. Store pins (19, View F) in straps (18).
12. Attach two legs of the lifting sling to the lifting lugs on
boom cap.
13. Hoist just enough so the slings are snug.
14. Remove pins (12, View C) and store the pins (View D).
15. Lift the boom cap away from the transition insert.
16. Place the boom cap on a trailer for shipping or on
blocking for storage.
17. Disconnect the lifting slings.
18. Reverse the Prepare Boom Cap steps on page 4-19 to
store the wire rope guide and to store the mast straps
and links.
Disassemble Boom Sections
Reverse the assembly steps on page 4-15 to disassemble
the boom.
• If the transition insert will be shipped with the wind
attachment, strap brackets (15, Figure 4-24) can remain
attached to the transition insert. Store the straps as
shown.
• If the transition insert will not be shipped with the wind
attachment, remove strap brackets (15, Figure 4-24)
from the transition insert. Store strap brackets (15) on
the boom cap as shown in Figure 4-11, View A.
Disassemble Crane
Refer to the Crane Operator’s Manual for disassembly
instructions.
IDENTIFYING PARTS FOR SHIPPING
To determine which parts must ship together from one job to
another, refer to Figure 4-25.
FIGURE 4-24
15
Boom Strap at End
of Transition Insert