Manitou MC 40 Powershift, Руководство пользователя

Страница: 74 / 102

3 - 16
C - EVERY 200 HOURS SERVICE
Carry out the operations described previously as well as the following operations.
C1 - A
LTERNATOR
/
FAN
/
CRANKSHAFT BELT TENSION
CHECK - ADJUST
- Open the I.C. engine bonnet.
- Check the belt for signs of wear and cracks and change if necessary (See chapter :
FILTERS CARTRIDGES AND BELTS in paragraph : 3 - MAINTENANCE).
- Check the belt tension between the pulleys of the crankshaft and of the alternator.
- Under a normal pressure exerted with the thumb (45N), the tension should be
approximately 10 mm.
- Carry out adjustments if necessary.
- Untighten screws 1 (Fig. C1) by two to three thread turns.
- Swivel the alternator assembly so as to obtain the belt tension required.
- Retighten screws 1 (Fig. C1).
If the alternator belt has to be changed, check the tension again after the first 20
hours of operation.
C2 - M
AST UPRIGHTS
CLEAN / GREASE
MC 40/50 POWERSHIFT Série 2
OPERATION TO BE DONE BEFORE OPERATING A NEW LIFT TRUCK AND ONCE
AT 250 HOURS SERVICE.
- Clean and remove the grease on all the lenght of the mast uprights (Fig. C2) Be very
careful when the lift truck is used in very dusty atmosphere.
- Check carefully the differents rollers to discover any traces of wear and change it if
necessary.
- Lubricate very slightly with grease (See chapter : LUBRICANTS AND FUEL in
paragraph : 3 - MAINTENANCE) all the lenght of mast uprights.
In case of technical faults, consult your dealer.
C3 - P
ARKING BRAKE
CHECK - ADJUST
Place the lift truck on a slope less than 15 % with the rated load in the transport position.
- Check the tightening adjustment by locking the parking brake in position A (Fig. C3/1).
- The adjustment is correct when the lift truck is held stationary on a slope.
- Carry out adjustments if necessary.
ADJUSTMENT OF THE PARKING BRAKE CABLE ON THE FRONT AXLE
- Press and release the brake pedal, then release the parking brake, putting it in position
B (Fig. C3/1).
- Unscrew nuts 1 (Fig. C3/2).
- Adjust the cable by untightening nuts 1 (Fig. C3/2), until a clearance of 1.5 mm
between cams 2 (Fig. C3/3) and stops 3 (Fig. C3/3) is obtained.
C1
C2
C3/1
1
1
A
B
4