1 - 22
I
NTRODUCTION
The following recommendations are intended to prevent the lift truck from being damaged when it is withdrawn from service for
an extended period.
For these operations, we recommend the use of a
MANITOU
protective product,
reference 603726
.
Instructions for using the product are given on the packaging.
Procedures to follow if the lift truck is not to be used for a long time and for starting it up again afterwards must be performed
by your agent or dealership.
P
REPARING THE LIFT TRUCK
- Clean the lift truck thoroughly.
- Check and repair any leakage of fuel, oil, water or air.
- Replace or repair any worn or damaged parts.
- Wash the painted surfaces of the lift truck in clear and cold water and wipe them with a soft cloth.
- Touch up the paintwork if necessary.
- Shut down the lift truck (See chapter : OPERATING INSTRUCTIONS in paragraph : 1 - OPERATING AND SAFETY
INSTRUCTIONS).
Make sure the mast cylinder rods are all in retracted position.
P
ROTECTING THE INTERNAL COMBUSTION ENGINE
- Fill the tank with fuel (See chapter : A - DAILY OR EVERY 10 HOURS SERVICE in paragraph : 3 - MAINTENANCE).
- Empty and replace the cooling liquid (See chapter : F - EVERY 1600 HOURS SERVICE in paragraph : 3 - MAINTENANCE).
- Leave the internal combustion engine running at idling speed for a few minutes, then switch off.
- Replace the engine oil and oil filter (See chapter : D - EVERY 400 HOURS SERVICE in paragraph : 3 - MAINTENANCE).
- Add the protective product to the engine oil.
- Run the internal combustion engine for a short time so that the oil and cooling liquid circulate inside.
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
- Cap the engine breather pipe hole.
- Remove the injectors and spray the protective product into each cylinder for two seconds with the piston in low neutral
position.
- Turn the crankshaft once slowly and refit the injectors (see internal combustion engine REPAIR MANUAL).
- Remove the intake hose from the manifold or turbocharger and spray the protective product into the manifold or turbocharger.
- Cap the intake manifold or turbocharger hole with waterproof adhesive tape.
- Remove the exhaust pipe and spray the protective product into the exhaust manifold or turbocharger.
- Refit the exhaust pipe and block the outlet with waterproof adhesive tape.
NOTE : The spray time is noted on the product packaging and must be increased by 50% for turbo engines.
- Open the filler plug, spray the protective product around the rocker arm shaft and refit the filler plug.
- Cap the fuel tank using waterproof adhesive tape.
- Remove the drive belts and store them in a safe place.
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
P
ROTECTING THE LIFT TRUCK
- Set the lift truck on axle stands so that the tyres are not in contact with the ground and release the handbrake.
- Protect the steering cylinder rods against corrosion.
- Wrap the tyres.
NOTE : If the lift truck is to be stored outdoors, cover it with a waterproof tarpaulin.
IF THE LIFT TRUCK IS NOT TO BE USED FOR A LONG TIME
Содержание MC 40 Powershift
Страница 101: ...4 11...
