Manitou MC 18-2 D K ST5 S1, Руководство оператора

Страница: 95 / 120

REPLACE Alternator belt
IMPORTANT
Check the belt tension again after the first 20 hours of operation.
- Remove the access panel 1.
- Loosen screws 2 by two to three thread turns.
- Swivel the alternator assembly so as to free the belt 3.
NOTE: Take the opportunity provided by the removal of the belt to check that the
pulleys and bearings are working correctly (noise, friction, play, etc.).
- Remove the belt and replace with a new one ( FILTER CARTRIDGES AND BELTS).
- Ensure that it is properly seated in the grooves of each pulley.
- Adjust the belt tension between the crankshaft and alternator pulleys.
- Swivel the alternator assembly so as to obtain the required belt tension.
- Under normal pressure applied by the thumb (98 N), belt movement A should be
between 10 and 12 mm.
- Retighten the screws 2.
REPLACE Hydraulic return oil filter cartridge
Place the lift truck on level ground with the engine stopped.
IMPORTANT
Do not operate the lift truck without the cartridge in place, as this would immediately damage the hydraulic
transmission system, the pump and the hydrostatic wheel motors.
- Release the pressure from the circuits by operating the hydraulic controls.
- Open the engine cover ( 2 - DESCRIPTION - INSTRUMENTS AND CONTROLS).
- Carefully clean the outside of the filter and the area surrounding it
- Unscrew the plug 1 with a wrench.
- Remove the hydraulic oil filter cartridge 2 from the filter head 3 and replace it with
a new one ( FILTER CARTRIDGES AND BELTS).
- Refit the unit.
3 - 23
A
1
2
2
2
3
2
3
1
647837 M1 (A052020) MC 18-2/18-4 D K ST5 S1