Manhattan 160872, Руководство пользователя

Страница: 6 / 12

5. Plug the AC power cord (attached to the rear of the subwoofer unit) into an electrical outlet
and set the main power button (also on the rear panel of the subwoofer) to the on position.
This allows you to then use the more convenient controller on the front of the subwoofer and
the button on the remote control to bring the speaker system out of the standby mode.
6. With the audio source turned on and generating an audio signal, adjust the volume and bass
level of the speaker system to desired levels (adjusting the volume/audio output level on the
audio source as necessary).
NOTE:
If connecting to a computer, you may want to conduct a
sound card test. With the speakers properly connected and turned on, find the computer’s
sound card in the device manager and begin the test. Each channel should be able to be
tested for sound and link. With the “test” window still open, turn up the volume on each channel
(speaker). Test sound should be audible: If not, check and deactivate the mute feature (press
mute button once) and do the test again.
OperatiON
The one-key controller and LED indicators are located on the front panel of the subwoofer, with
buttons that perform similar functions on the remote control (see Remote Control below).
Power
When the main power button (on the rear panel of the subwoofer; see Setup Step 5) is in the
on position, the ST_BY LED lights red, indicating that the front-panel and remote controls are