C o n n e c t o r a s s e m b l y
C o n n e c t o r “ N ” t y p e : C . N . H Y F 5 M - S
C o n n e c t o r “ U H F ” t y p e : C . U H F. A C 5 M - S
Make a circular cut on the black
PVC outer jacket at the indicated
length shown in the caliber (in mm).
Subsequently remove it.
After having made the first cut,
as shown in picture 2, rotate the
cable 180 degrees and make a
second cut in the same way, in
order to facilitate the introduction
of component D (pic.4 and 5)
Insert component D after hav-
ing opened the braid as shown
in the picture. Push component
D between the foil and the braid
until it stops against the red PE
jacket.
Flatten the wires as shown in the
picture and cut the excess.
Cut and remove the tape and dielet-
ric for a lenght as shown in the pic-
ture (in mm).
Insert one of the two teflon discs and
subsequently the central pin. Solder
the pin to the inner conductor, insert-
ing tin in the provided hole. Avoid
heating the pin for a too long time in
order not to damage with excessive
heat the cable dielectric.
(which is not made in teflon!)
Insert the second teflon disc as
shown in the picture.
Insert the connector and fasten
accurately until the o-ring present
in component A, will be pressed
against the connector body. Inside,
the rubber component C (pic. 1)
will expand, granting optimal seal-
ing against moisture and a perfect
contact to ground.
Insert in the cable components A,
B, C and immediately after, make a
circular cut on the jacket at the in-
dicated length shown in the caliber.
(in mm). Subsequently remove it.
Insert component D after having
opened the braid as shown in
the picture.
Push component D between the
foil and the braid until it stops
against the jacket.
Flatten the wires as shown in the
picture and cut the excess.
Cut and remove the tape
and dieletric for a lenght as
shown in the picture.
Fasten together the connector and component A, until it will be pressed against
the connector body. Inside, the rubber component C (pic. 1) will expand, granting
optimal sealing against moisture and a perfect contact to ground.
Insert the connector and solder it with
tin to the inner conductor (see picture
above). Avoid heating for a too long
time in order not to damage with
excessive heat the cable dielectric
(which is not made in teflon!)
1
2
3
4
A
B
C
D
D
5
6
7
8
1
A
B
C
18 mm
2
3
D
4
7
5
6
D
Messi & Paoloni srl
Via G. Conti 1 - 60131 - Ancona
Tel. +39.0712861527
Fax. +39.0712861736
www.messi.it - [email protected]
