SP180-H | 1.03.01
www.mc-techgroup.com
13
13.1
Connecting the heated sample line
•
To connect the sample line, a threaded tube connector
with Ø 6 x 1 mm is available – other diameters
available on request.
•
Open metal clamp
.
•
Insert the tube connection piece into the bolted pipe joint
and connect them.
•
If you use a PTFE tube as sample line, a metal tubing sleeve for pneumatic fittings needs to be inserted at
the end of the tube to prevent it of being pressed together.
•
The temperature-resistant, stainless steel connector
from M&C has a double-blade ring system to ensure
reliable sealing. First finger-tight the nut of this connector, then use a flat spanner to turn the nut exactly
1¼-turns. The nut is now correctly mounted.
•
Place the heated sample line into the open metal clamp
and close the clamp.
Note
Make sure that the connection is leakproof!
13.2
Connecting the test gas line
•
To connect the test gas line, a threaded tube connector with Ø 6 x 1 mm (DN4/6) is available (see Figure 1)
•
If you use a PTFE tube as sample line, a metal tubing sleeve for pneumatic fittings needs to be inserted at
the end of the tube to prevent it of being pressed together.
•
The temperature-resistant, stainless steel connector
from M&C has a double-blade ring system to ensure
reliable sealing. First finger-tight the nuts of these connectors, then use a flat spanner to turn the nuts
exactly 1¼-turns. The nuts are now correctly mounted.