14
•
do not connect and disconnect hydraulic hoses when the tractor hydraulic system
is pressurised (hydraulics set to neutral position),
•
check regularly the conditions of connections and hydraulic hoses,
•
do not use the implement until the hydraulic system is repaired.
3.4.
Transport safety on public roads
For transport, the plough must be turned to the centre position (the frame should be in
the tractor’s axis) and then locked with a pin. Before turning, raise the plough to a point
where it does not interfere with the ground. During transport, the clearance under the
lowest part of the plough should prevent collision with the ground during transport on
uneven ground. When driving with the plough on public roads, it is mandatory to use
driving lights, a distinctive warning sign and side reflectors.
Do not exceed the speed limits during transportation, which are:
•
up to 20 km/h on smooth
-
surface (asphalt) roads,
•
6
-
10 km/h on country roads or cobblestones,
•
up to 5 km/h on bumpy roads.
Adapt the driving
speed to the road conditions to prevent the plough jumping on the three
-
point hitch and to prevent excessive loads on the implement frame and the three
-
point
hitch.
Maintain particular caution when passing and overtaking and on bends. The permissible
width of the implement travelling on public roads is 3.0 m.
Do not drive with the implement if the slope is inclined crosswise to the implement by
more than 7°.
Be aware of the length of the plough. In sharp turns, the plough leans against the direction
of the
turn. This may result in a collision with obstacles or other road users.
During transport the plough is to be secured with the lock that keeps the plough on the
same axis as the tractor, reducing its transport width and increasing the stability of the
vehicle during transport. For locking, use the lever that you need to turn so that it jumps
out of its slot and so that the pin holds the tow bar head in the locked position. Once
locked, the plough cannot be turned because damage to it may occur. To unlock, turn the
lock lever so that it falls back into its slot.
