Man D2862 LE221, Руководство по ремонту

Страница: 365 / 420

CRANKCASE
FLYWHEEL HOUSING
Removing, installing the ywheel housing
Additional jobs
–
Removing, installing the combination air lter, see 187
– Removing, installing engine control units, see 27
– Removing, installing the combination air lter holder, see 193
– Removing, installing the engine wiring harness, see 25
– Removing, installing the charge air manifold, see 181
– Removing, installing the cooling system, see 55
– Removing, installing the fan V-belt, see 85
– Removing, installing the ramfan, see 61
– Removing, installing the intermediate ange, see 63
– Removing, installing the fan tensioning pulley, see 89
– Removing, installing the fan carrier with fan bearing, see 91
– Removing, installing the coolant pump coolant manifold, see 73
– Removing, installing the high-pressure pump/high-pressure pump drive, see 129
– Removing, installing fuel lines, see 141
– Removing, installing coolant lines, see 65
– Removing, installing the ywheel, see 315
– Removing, installing the rear radial shaft seal, see 300
(1) Flywheel housing
Technical data
Screw plugs ......................................................... M38x1.5 ..........................................................240 Nm
AE6 3st edition 363