Mammoth M.DC.T.ID.12.S, Руководство пользователя

Страница: 11 / 13

EN
11
ENVIRONMENTAL PROTECTION
Disposal of the packaging
The packaging consists of cardboard and correspondingly marked
plastics that can be recycled. Make these materials available for recycling.
Disposal of the appliance
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
4. Chuck adjustment
To open the chuck jaws rotate the front section of the chuck. Insert the drill bit
between the chuck jaws and rotate the front section in the opposite direction.
Ensure the drill bit is in the center of the chuck jaws. Finally, firmly rotate the
front chuck section in the opposite directions, Your drill it is now clamped in the
chuck.
5. Torque adjustment
（
Screw driving force of your drill driver
）
The torque is adjusted by rotating the torque adjustment ring.
The torque is greater when the torque adjustment ring is set on a higher setting.
The torque is less when the torque adjustment ring is set on.
Low setting, e.g. small screws, soft materials
High setting, e.g. large screws, hard materials
Max setting for heaving drilling
6. Drilling
When drilling into a hard smooth surface, use a center punch to mark the desired
hole location. This will prevent the drill bit from slipping off center as the hole is
started. Hold the tool firmly and place the tip of the bit at the point to be drilled.
Depress the switch trigger to start the tool. Move the drill bit into the work piece,
applying only enough pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
7. Using the LED light
The LED light allows you to keep a clear view under less illuminated
circumstances. To turn on the light simply press the on/off switch. When you
release the on/off switch, the light will be off.
8. Battery capacity indicator
The three LED lights(3) will indicate the current battery capacity when pressing
the switch(4).
1.LED light on: around 30% of capacity
2.LED light on: around 60% of capacity
3.LED light on: over 90% of capacity
DESCRIPTION OF SYMBOLS
Pay attention to all the signs and symbols shown in these instructions and on your
tool.
Make a note of these signs and symbols. If you interpret the signs and symbols
correctly, your work with the machine will be safer and better.
Always use breathing apparatus when machining materials which
generate dust
Double insulated
End of life machines contain valuable materials and therefore they
should not be placed in household waste. We would ask you to play
your part in protecting resources and help protect the environment
by returning this machine to a return point (if one is available) when
it reaches the end of its life
Wear good quality, strong gloves