Detaching the Roll Film Holder
1. Insert the Dark Slide (9) into the slot marked with white lines
2. Hold the Roll Film Holder at the Rubber Finger Rests (12)
3.
Push the holder’s Lock Release Button (B) in while sliding the Detaching Button (A) downward.
The holder can be removed from the body. If the dark slide is not inserted into the holder, the
Detaching Button cannot be depressed.
The Roll Film Insert
1.
Open the back cover by depressing the Back Cover Lock Button (A).
2.
Position film in the direction shown.
3.
Press in on both sides of the Attaching/Detaching Release and insert the Roll Film Insert into
the Roll Film Holder.
4.
When the Roll Film Holder is pushed in, the Release will click and lock.
5.
After the Roll Film Holder is locked into place, close the Roll Film Holder’s Back Cover.
Memo Clip
The Memo Clip on the Back Cover, see Fig. 3, is used to hold the end of the film box to indicate the type
of film loaded in the Roll Film Holder.
Film Speed Dial
The ISO setting on the Film Speed Dial, see Fig. 4, communicates the film’s ISO to the AE prism finder. Be
sure to set the dial correctly.
