TROUBLESHOOTING GUIDE:
TROUBLE RECOMMENDED SOLUTION
Vehicle does not start Turn the Main Power Switch to ON Position to allow power into the
booster clamps.
Allow the Boost 200 to stay connected to the vehicle battery for a longer
period of time. Wait 6 to 8 minutes before attempting to start the vehicle
again.
Recharge the Boost 200 Power Supply to FULL charge status.
Replace the vehicle battery or visit workshop/garage for further
assistance.
110 V electronic device Recharge the Boost 200 Power Supply to FULL charge status.
does not operate with the
200 Watt inverter Check for proper rated power required to turn on the electronic device. If
the electronic device wattage is rated above 200 Watt, remove the
Device since the operating wattage is above the maximum output power
of the inverter.
Check the connection of the electric device to the inverter receptacle.
Check the inverter fuse. To replace the inverter fuse, using a needle nose
pair of pliers or fuse puller, remove the old fuse and replace with a 25A
blade type fuse
12 Volt DC devices Recharge the Boost 140 Power Supply to FULL charge status.
connected to the 12 Volt
output port of Boost 200 Insert the device 12 Volt plug properly into the Boos200 DC output port
does not operate.
Internal Circuit Breaker is OFF. Remove the 12 Volt Accessory plug from
The Boost140 12VDC output port. Wait 15 - 25 minutes for automatic
Reset to regain power.
Compressor does not Recharge the Boost 200 Power Supply internal battery to Full charge.
turn on.
Compressor doe not inflate Make sure the hose nozzle is properly seated and the locking lever is in
down position.
Repair air hose if possible.
Allow 15 - 20 minutes for compressor to cool down before re-use.
USB powered device Press the USB output port SWITCH to ON position (
—
)
connected to the USB of
Boost200 does not function Insert the device USB plug properly into the Boost140 USB port.
Model No. 2032
S
he
et
8
of
9
