Positive Grounded System:
I.
Connect the BLACK CLAMP (negative -) to the negative terminal of the vehicle battery.
II.
Connect the RED CLAMP (po) to the vehicle engine block, or a metal part of the
vehicle which is connected to the vehicle ground system. Do not clamp directly to positive
battery terminal, main fuel distribution module or sheet metal parts.
7. Turn on the Main Power Switch by rotating the switch to the ON position. The BLUE LED will
illuminate indicating power is available in the booster clamps.
8. Allow 3 to 5 minutes of charge time. It is highly recommended having a second person to assist
holding the unit securely in place during the next steps.
9. Start the engine. Stop if the vehicle does not start after 2 to 3 seconds of engine cranking. Wait 2 to
3 minutes then try again. Repeat the above steps several times until the vehicle starts.
10. If the vehicle starts, turn off the Main Power Switch by turning the switch to the OFF position.
11. Disconnect the clamps as far away from the vehicle battery as possible.
For Negative Grounded System, disconnect the BLACK CLAMP Negative first and then the RED
CLAMP Positive.
For Positive Grounded System, disconnect the RED CLAMP Positive first, and then the BLACK
CLAMP Negative.
12. Stow the booster clamps into their storage compartment.
12 VOLT DC CHARGER ADAPTOR FUSE REPLACEMENT:
1. Unscrew the retainer ring at the tip of the 12 Volt DC charger plug.
2. Replace the internal glass fuse with the same grade Fuse rated at 2 AMP.
Model No. 2032
S
he
et
7
of
9
