Mamba AirCombi, Руководство по эксплуатации

Страница: 15 / 16

AirCombi Spray Gun
Page 15 OPERATING MANUAL
MAMBA
PROBLEMS
Low flush of materials
The spraying is not even
Gun leaks
Gun leaks air
Gun do not spray
Spraying not uniform
CAUSES
a. Gun butt filter is clogged
b. Viscosity is too high
c. The nozzle is too big or clogged
d. Working pressure is too low
a. Nozzle is clogged
b. Gun butt filter is clogged
c. The nozzle is too big or clogged
b. Viscosity is too high
e. Atomisation air is too low
f. Material passages are clogged
g. Compressed air is too high
a. Seal screw is worn or too loose
b. Diffuser is worn
c. Needle is worn
a. Air valve set (pos. 18) is worn
a. Filter clogged
b. Material hose clogged
a. Nozzle partially clogged
b. Nozzle worn
REMEDIES
a. Clean it or replace it if necessary
b. Thin the product
c. Replace it with a smaller one
d. Increase the pressure
a. Clean it or replace it if necessary
b. Clean it or replace it if necessary
c. Replace it with a smaller one
d. Thin the product
e. AIncrease the pressure
f. Clean the material passages with a
plastic brush (not in metal)
g. Reduce the pressure from the pump
a. Screw the seal screw adjusting nut
with a wrench nr. 7
b. Clean it or replace if necessary
c. Clean it or replace if necessary
a. Replace it
a. Replace it
b. Replace it
a. Clean with proper tools
b. Replace it
Our products are carefully tested and their quality is excellent, thus the gun-life and its good performance principally
depends on careful cleaning and maintenance.
11. Troubleshooting