Mamas & Papas Book, Инструкция по эксплуатации

Страница: 17 / 20

- 17 -
BRAKE: to set the brakes on the stroller, lower the
levers on the rear wheels with your foot (Fig.b). To
release the brakes, lift the lever.
Always set the brakes when the stroller is not
moving.
7• CUP HOLDER: The cup holder can be placed on left or
right side of the stroller through the hook fitted on both
sides of the chassis. To fit the cup holder, click it on
(Fig.a).
ADJUSTING THE HANDLES: the handles can be set into
4 different positions. For the highest position, push the
side buttons and lift the handle upwards at the same
time. Release the buttons. To lower the handles, do the
opposite (Fig.b).
8• HOOD: to assemble the hood, fasten the hood's side
attachments onto the sockets until they click (Fig.a);
expand the hood frame so that the fabric is fully
stretched (Fig.b).
9• Button the hood onto the stroller's backrest (Fig.c), on
both sides and inside the handle (Fig.d).
To remove the hood: unfasten the hood's side
attachments from the chassis by pressing the external
button (as shown in Fig.e) and unbutton it from the
backrest, the sides of the stroller and inside the handle.
10• The hood has:
- a fabric loop, for tying toys (Fig.a).
- a window with UV protection, to see the child (Fig.b).
11• The hood can be adjusted to two positions (Fig. a).
Undo the zip (Fig. b) and stretch the fabric flap to see
the child and to let more air under the hood (Fig. c).
12• RAINCOVER for complete Book:
to fit the rain canopy, Zip the hood and raincover
together. Attach the straps on the sides of the raincover
to the hood. Fasten them in place with the press studs
on the strap. Attach the straps at the bottom of the
raincover around the frame below the footrest.
• Do not use the rain canopy indoors and always make
sure that the child is not too hot.
• Do not place the rain canopy near heat sources and
pay attention to cigarettes.
• Make sure that the rain canopy does not interfere with
any moving mechanism of the stroller.
• Always remove the rain canopy before folding up the
stroller.
• Wash with a sponge and soapy water. Do not use
detergents.
13• 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
14• To tighten the waist strap, pull on both sides in the
direction of the arrow. To loosen it do the opposite.
15• To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
WARNING: To fasten the belts in the third eyelet, lift the
fabric, as they are hidden in the lining.
16• FREEDOM OF MOVEMENT: After 6 months, at the
discretion of the parents, the straps may be fastened
differently, to give your child more freedom of
movement, without jeopardising on safety.
- Detach the two buckles on the rear of the backrest (as
explained in paragraph 16).
- Slide the two buckles out from the front;
- Fasten the buckles, as shown in the figure, on both
sides of the waist strap.
17• ADJUSTING THE FOOTREST: the footrest can be adjusted
to 2 positions. To lower the footrest, push the two little
side levers downwards and lower the footrest at the
same time. To raise the footrest, push it upwards until it
clicks.
18• ADJUSTING THE BACKREST: the backrest can be reclined
into 8 positions. To lower the backrest, lift the handle
and lower the backrest at the same time. Block it in the
desired position. To raise the backrest, lift the handle
and raise the backrest at the same time. Block it in the
desired position.
19• FRONT BUMPER BAR: to attach the front bumper bar
remove the protection caps (Fig.a) and store them.
After removing the caps, insert the ends of the bumper
into the armrests until they click (Fig.b).
20• The bumper bar can be opened on one side so an older
child can climb on and off more easily. To open the
bumper bar, push the button on the side and pull the
bar outwards (Fig.a)
To remove the bumper bar, press the two buttons on
the sides and pull the bar outwards (Fig.b).
When the bumper bar is off, replace the protection
caps onto the chassis armrests to close them.
21• COLLAPSING THE STROLLER: to collapse the stroller,
put the front wheels into fixed position, close the hood
(if on the stroller) and remove the car seat (if on the
chassis).
- Align the handle with the stroller chassis as shown in
the picture (fig_a);
- lift the fastening hooks on the two sides of the chassis
(fig_b);
- Pull the interior handle placed behind the seat (fig_c)
and lift at the same time (fig_d).
22• Rotate the handle forward until completely closed
(fig_e).
Check that it has fastened to the closing hook on both
sides. If it has not, fasten the closing hook properly as
shown (fig_f).
The collapsed stroller is free standing.
23• To make the stroller smaller still, the back wheels can be
removed. Pull the pivot outwards and extract the wheel
as shown (fig_a).
TRANSPORT: the stroller can be carried comfortably
locking the front wheels and grasping the main handle
(fig_b).
24• REMOVING THE LINING: to remove the stroller's lining:
- unthread the belt's leg divider from under the seat
(fig_a);
- slip the elastics off their hooks on both sides (fig_b);
25• - unscrew the belt on both sides, keeping your finger
under the bolt (fig_c);
- unfasten the lining from the armrests as shown in the
picture (fig_d);
- lift the flaps and release them from the velcro fabric to
unbutton the seat's lining (fig_e);