XSERIES Instruction Manual
MaltaDynamics.com | 800-494-1840
10
Before using the unit, be sure to read, understand, and follow the instructions that come with
your system. Knowing how to use the system properly will greatly reduce the possibility of injury.
1.
Using vehicle, position the unit as close as possible to working location (Unit may also
be positioned with the optional Go! Friction Drive System). When possible, place the
system on a solid, level surface. The surface must be suitable for supporting the machine.
in the case of a fall. The unit may remain connected to the vehicle as long as ALL fall
forces are absorbed by the XSERIES Mobile Grabber. When positioning the unit, be sure
to allow enough clearance for the mast to raise without interference
2.
Starting at the anchor side of the machine, adjust the two outrigger jacks until the level
indicator shows that the unit is level.
NOTE: The outrigger jacks, NOT the tires, must support the system’s weight. The tires may be in contact with the
ground, but the load must be on the outriggers.
3.
Moving to the tow-side of the unit, repeat Step 2 until unit is level.
NOTE: Double check to ensure that the system is level in both directions. The unit MUST be within 2 degrees of level
before each use.