Malta Dynamics A6101, Инструкция по эксплуатации

Страница: 10 / 17

Beam Trolley User Instruction Manual
MaltaDynamics.com | 800-494-1840
10
4. Slide the adjustable rollers so that both sets of rollers are fully resting
on the beam flange.
5. Release the toggle plate and pull back on the adjustable rollers to
ensure the ratchet teeth are fully seated in the nearest ratchet
notches.
6. Tug, rock, and twist the anchorage connector in all directions to
ensure that it can not come off of the flange.
7. Screw tight the secondary safety locking screws on the bottom of the
toggle plate to ensure the rollers can not move off the edge of the
flange.
8. The rollers must ride on a clear, clean surface. Remove any dirt and
grit if necessary.
9. Ensure that Beam Trolley can not slide off end of beam it is
attached to. Install stoppers if necessary.
*Always re-adjust according to Installation steps 1-9 when moving to a
new or different sized beam.
*Remove any dirt
and
grit if
necessary.
*Weld or bolt in
stoppers
if necessary
to ensure that Beam
Trolley can not slide
off the end.
Manual Revision Code:
M ARCH 30,2021