27
REMOTE CONTROLLER
1. Press the button to start the appliance, when
plugged in. When in operation, press the button
to set the appliance to standby mode.
2. Press this button select the operation mode.
3. Use to select fan speed in sequence
or
4-5. Use to adjust the room temperature and the
timer.
6. Use to set or cancel
mode operation.
7. Use to set automatic off and automatic on time.
1
2
3
6
7
5
4
1. Push the locking device and pull out the bat-
tery compartment.
2. Take off the isolating film on the battery.
3. Put the battery inside the slot. For correct
polarity, see the “+” mark on the battery
compartment.
4. Push the battery compartment back into the
remote controller. The plus pole should be fac-
ing the back cover.
How to install battery
Signal receptor
How to Use
To operate the air conditioner, aim the
remote controller at the signal receptor
or press the buttons on control panel.
Note:
•
For long time no use, take out the battery.
•
To prevent environmental pollution, take out the used battery and dispose safely and
appropriately.
