Malloca WQP6-87CP, Руководство пользователя

Страница: 11 / 48

16 17
■
Instructions
■
Touch instructions
■
Start
◆
The operation interface
If it is the very first initialization for the dishwasher, then the Choose Program screen is shown:
“ ”
◆
Lid motor operation
1. When press the "stop/start" button to boot, the top motor will drive the top drawer downward
seal, and then the program will start.
2. The program is running mode, press the "stop/start" button to suspend the program runs.
Within the prescribed period of time, the top motor driveUpward, completely release the machine
head, a buzzer two sounds to inform lid seal has been released.
3. After the start the program or in the process of the program is running, not to pull out the drawer,
have to press the "stop/start" button,
Such as roof upward in place after the buzzer two to pull out the drawer.
By pushing ( ) with “OFF” selection, the time delay is cancelled and Program Selection
mode is set back.
●
By pushing ( ) with any other selection, the time delay is set and Time delay starts
counting down every minute.
●
During Time Delay Counting mode, after the time delay is exhausted the washing program
is started in the standard operation way (see Program running mode).
Note: Once Time Delay mode is set, the door must be sealed through the Lid motors. So,
If the user needs to access the basket, this mode must be cancelled first.
Settings can be configured by using a button combination during Start or Program Selection
mode. By pushing ( ) + ( ) (for 2 seconds), the settings menu is entered.
If ( ) is pressed with “back” selection, it returns back to Program Selection mode.
By pressing ( ) it switches between settings.
By pressing ( ) while any setting is selected, the corresponding setting submenu is entered
in order to change the preferences.
It is possible to activate a time delay for the washing program to start.
The time delay can be activated by pushing ( ) + ( ) keys for 3 seconds during Program
Selection mode.
During Time Delay Selection mode, time delay changes in 1 hour steps (counting up) by
pressing ( ). The time delay at a maximum can be 9 hours: “+ 9”.
The complete sequence while pressing ( ) is:
◆
Time Delay
◆
Settings
1.Dark after Welcome-letters ;
2.After Welcome-letters passing: (Choose Program);
3.Continuous Welcome-letters.
●
After pushing “ ”(program) button, program selection is started.
●
For the next starts, the last program used, should be pre-selected, so that display shows the
last run program and can be started immediately by pushing “Start/Pause”.
●
By Pushing “ ” (Program button), you can choose the washing program/ profile.
The Washing profile name is shown in the display and is shown in a short form:
●
Alternating to the program name (short form) at display the related
program time segments are displayed. This alternating/ switching
between program name and related program time (e.g. every
2seconds) ends by pushing “Start/Pause” to start the program.
From there on only the program time is displayed and counted
down based on the profile definition.
●
After the program is started, only the program time is displayed and starts to count down as
long as the program is in progress. Time values are display steadily, the dots in between are
displayed with flash.
●
By pushing the Start/Pause button during the program is running, the program is paused.
At display the related program time is displayed flashing. The dots in between are displayed
steadily. When the “ ”button is pushed again, program continues. Remaining time display
continues counting down.
◆
Operating Mode