Malem MO4, Руководство пользователя, Страница: 5 / 16

5 | P a g e
children, loop and tie the cord/wire to shorten length. Attach alarm to material before
wearing garment is preferable. For vibration alarms, attach on the inside of close fitting top
close to the collar bone. A common reason for the alarm not sounding is disconnection or
dislodgment of the alarm from the sensor or wire. The lever to close the grippers on the
alarm has to be pushed UP to close the grippers. FORCEFULLY PUSHING IT DOWN WARDS
WILL BREAK THE PLASTIC LEVER.
o
There is no On/Off switch that could allow the alarm to be switched off and ignored.
The reset button will stop the alarm from sounding only if the Easy-Clip lever is LIFTED
OPEN and REMOVED from the underwear. It is intentional that one of the sounds of the
Eight Tone alarm MO4 (8) does not stop immediately upon pressing the reset button.
o
Cleaning alarm unit: Wipe clean alarm and safety pin/clip using mild detergent or skin
disinfectant. Use damp cloth and dry thoroughly. NEVER IMMERSE IN WATER.
o
Batteries: The alarm's NON-rechargeable batteries are two triple A (AAA) type alkaline
batteries. In normal use it needs to be replaced every four weeks. Maximum continuous
operating time is about 10 hours. Batteries should be replaced by adults. Please see more
detailed instructions on page 14 and watch the video. To change the batteries, remove the
battery cover by twisting a slotted screwdriver in the space at the top of the cover. The
battery cover needs to be opened carefully with a pushing and sliding movement,
otherwise the small plastic clip that keeps it closed breaks. Take special care to observe the
correct polarity when replacing the batteries. Make sure the batteries are not loose within
the compartment and the contacts are clean. Do not mix old and new batteries. Important:
Remove batteries and clean sensor if the alarm is not going to be used for some time.
o
Choice setting: To change setting combination, remove battery cover and slide lever
inside battery compartment:
-
Position 1 = Sound only;
-
Position 2 = Sound and Vibration;
-
Position 3 = Vibration only. See image below.
-
The MO24 has the option to record a message if the alarm sound is not tolerated.