Malaguti XTM 50, Руководство по ремонту

Страница: 18 / 42

A
18 05.03
CHAPTER
PAGE ISSUE
CHASSIS
ENGLISH
SECTION 2
Getting to know your motorbike
SECTION 2
A
- CHASSIS
R
S
F
MIN
MAX
MIN
A
V
2
F.13i
F.14i
F.15i
B
TRANSMISSION OIL
Replacement
Park the vehicle on flat ground.
2.Start the engine and warm it up for several minutes.
3.Stop the engine. Place an oil pan under the engine
and remove the filler cap (R - F.13i).
4.Remove the drain screw (S - F.13i) and the screw (F -
F.13i) to drain oil.
5.Reinstall the drain screw (S - F.13i) and tighten it.
6.Fill the engine with oil until this is dripping from the
level control hole (F - F.13i). Fit the screw back into the
hole (F - F.13i), install the oil filler cap (R - F.13i) and
tighten it.
The use of SAE 10W 30 oil is recommended.
Start the engine and let it warm up for a few minutes.
While it is warming up, check for oil leakage. If oil is
leaking, immediately turn off the engine and locate the
cause.
BRAKE FLUID
CHECK
When checking the fluid level, make sure that the top
end of the main cylinder is horizontal when the handle-
bar is turned.
Make sure the brake fluid level of the rear brake reser-
voir is above the minimum level mark. As far as the front
brake is concerned, the level of fluid can be checked
through the sight glass on the pump.
REPLACEMENT
Front brake: remove the cap (A - F.14i) after loosening
the screws (V2 - F.14i).
Rear brake: remove the cap (B - F.15i).
Brake fluid quality must comply with the specified stand-
ards; brake fluid may deteriorate rubber gaskets, caus-
ing leaks and impairing brake operation.
Recommended brake fluid: DOT 4