Malaguti CNK 50 DRAKON, Руководство по ремонту

Страница: 16 / 80

A
DRAKON 50 NKD
4
16
03/06
INSTRUMENT
AND CONTROL FUNCTION
FRAME AND RUNNING GEAR
DIGITAL INSTRUMENT PANEL
This new digital instrument board offers several additional functions- compared to traditional ones - through which
driver may optimally manage his/her vehicle. The panel is equipped with a warning light signalling shortage of coolant
or improper connection with the radiator’s thermostat. This light comes on automatically. To select the functions shown
on the display, press the MODE button located at the front of the left hand control (see page 18).
Available functions are:
0-40 (acceleration from 0 to 40 km/h),
TIME (clock),
LAP (chronometer),
AVE (average speed),
TD (partial distance),
TOD (total distance),
BAR GRAPH with three functions: battery charge level, coolant temperature, number of engine revolutions.
For the English version, the display will be in miles, not km. The digital instrument board only works
if the battery is connected. If the battery is flat, replace it immediately. When the battery is replaced or
the fuse is removed, power is disconnected; any settings memorised on the instrument panel, except
the total distance travelled, will be reset.
Replace the flat battery with a new one; if the problem remains, call an Authorised MALAGUTI Service Centre.
Do not use your vehicle when no function appears on the display or when functions appear partially,
since the instrument board is not in the condition to provide sufficient information about your vehi-
cle.
SETTING
Power up the instrument board by connecting the battery to the vehicle’s cables. Put the key in the ignition switch and
turn it to. The names of stored flywheels appear successively on the display: before selecting your type, check the type
of flywheel installedon your vehicle on the anti-tampering label under the seat (seepage 33). When the code of your
model appears on the display, press the MODE button, to make your selection. If you choose the wrong model, you will
be shown improper information (speed, km, etc.). If you choose the wrong model, turn the panel off, wait for about two
minutes and repeat the above operations in the correct manner.
These operations must be repeated every time the battery is disconnected.
MILES OR KILOMETRES SELECTION
If you are driving in countries with different measurement systems, you can change the unit of measurement of speed
(instant and average) and distance from kilometres to miles and vice versa. To make your selection, first of all the
vehicle must be stationary. Now hold the MODE button down for 5” after selecting the TOD function. When „Mph“ and
„Km/h“ appear, give the MODE button short presses until the unit of measurement starts flashing. Hold the MODE
button down to save your selection. The instrument board will return to its normal display mode. Any stored information
(with the exception of TOD) will be reset.
Using a unit of measurement that differs from the one used in the country where you are driving may
lead to improper calculations, especially concerning the vehicle’s speed. Consequences include ex-
posure of the driver and others to dangers, as well as fines.