Date of publication 15th October 2014
www.malacrino.co.uk
- 6 -
Thermal cut out
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on an off by a utility.
The thermal cut-out fitted in the heater is non-self- resetting that is reset by
disconnecting it from the mains.
The appliance is fitted with a thermal cut out, if the appliance fails to operate, the thermal protector
may have operated and set the appliance to no heat status.
In this event switch off the appliance at the double pole switched fuse spur or remove the three pin
plug from the socket and allow the appliance to cool and investigate the activation
Remove any item covering the heater or restricting the air flow. Switch on the double pole switched
fuse spur or insert the three pin plug. Operate the switches to restore the full operation
TO RESET THE THERMAL CUT OUT POWER TO THE APPLIANCE MUST BE DISABLED AND
THEN REAPPLIED
Cleaning and Servicing
1.
For general cleaning use a soft clean duster or soft brush, a vacuum cleaner may be used on
the fuel effect bed
2.
The decorative trims on this appliance have protective coatings; remove from the appliance
before cleaning with warm soapy water and a soft cloth
3.
Do not use scorers, abrasives or chemical cleaners
4.
Always turn off the appliance and isolate the power supply before and maintenance
5.
If the supply cord ( type X attachment ) is damaged it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
6.
This appliance is fitted with a 1.5 Watt GU10 Led light bulb, to replace this bulb, switch off
and then isolate the appliance, remove the front fret with an upward and outwards sliding
motion, using a cross head screwdriver, remove the 4 screws holding the cover plate on,
remove the GU10 light bulb and replace with a 1.5 Watt GU10 LED light bulb, refit the cover
plate and fret
Disposal of appliance
This appliance is constructed from recyclable material, at the end of its life it should be recycled and
not disposed of as household waste, it can be returned to Malacrino Ltd or taken to your local
recycling centre for correct disposal
Malacrino Ltd registration no. WEE/GJ4682ST
