Date of publication 15th October 2014
www.malacrino.co.uk
- 3 -
5.
Warning this appliance must be earthed
6.
This appliance is designed to be wired into a 13 amp double pole switched fixed spur
7.
If a standard 13 amp three pin plug is decided to be fitted then follow the instructions of the
standard three pin plug manufacturer
8.
Do not install this appliance into a chimney opening, it must be blocked to prevent any draft
affecting the heater fan unit, the overheat limit switch may activate and disable the appliance
9.
Do not use this heater in any surroundings where water is present, such as bathrooms or
swimming pools
10.
Do not locate this fire onto thick pile carpet
11.
Do not place clothing or objects in front of the heater outlet, it may cause overheating or fires
12.
This appliance uses fans to produce the realistic flame effect and to disburse the heat, as a
result their may be some normal residual back ground noise while they are in operation
13.
Please keep these instructions for future reference
14.
This appliance is not designed to be a primary heat source
Installation
1. The switched fused spur or three pin mains plug must be accessible after installation
2. Ensure that adequate space is available to route the electric supply cable
3. This appliance has one installation option
4. The minimum size of the opening is 385 mm wide by 545 mm high and 75 mm deep
5. The maximum size of the opening is 420 mm wide by 570 mm high and 100 mm deep
Option one (direct screw fitting)
Fix the four screws provided at the dimensions listed below, In the event the screw cannot self
screw into the fixing material, drill a 6 mm hole into the material using a suitable drill and drill bit
and insert the red plugs to fix into, taking care not to damage the hard material
450 mm
435 mm
435 mm
104 mm 104 mm
