Maktek 25 MKP, Руководство по эксплуатации и использованию

Страница: 13 / 25

13
4.3 VENTILATION
The area where the boiler is installed, must always be suppplied with fresh
air by opening a window or a duct. Fresh air is required in order to burn the
fuel safely and efficiently. Otherwise once the burning starts, the oxygen
level will drop and the burning will detoriate. Detoriation of burning will
cause the burning efficiency to decrease, accumulation of soot in the
chimney and will require frequent cleaning.
4.4 CHIMNEY
•
The chimney that will be connected to the boiler must be seperate .
The chimney must be connected to provide a dequate draught. A boiler
without chimney connection should not be operated.
•
Chimney connection pipe and pipe systematic should be installed and
checked by authorized people only. We remind you that the biggest
factor in boiler efficiency is chimney design and draught.
• Proper chimney connection pipe should not be smaller than the
boiler's chimney diameter, horizontal length must not be shorter than
60 cm and longer than 2 meters and pipe must be connected to the
chimney with minimum 10 degree of angle.
• We suggest not to use enamel stove pipes bause they cause tars in
chimney connection pipe or chimney system.
•
In case of an elbow use in chimney connection, the elbows must have
round and wide angle. Quantity of an elbow must be maximum 2
pieces.
•
Chimney connection must be installed to allow demounting from the
boiler and avoid gas leaking.
•
Chimney connection pipe must not be extended to the outside and
must be connected to a chimney.
•
Chimney connection pipe's contact with flammable material must be
avoided.
•
Chimney connection pipe shouldn't be pushed inside the chimney.
• The direction of the chimney should not be changed. If there is a
turnaround need,it must be positioned by 60 °C.
• The chimney must be leak proof and air transperancy from inside and
outside must be avoided.
•
Do not connect more than one boiler and another device to same
chimney. This would decrease chimney draught and boiler efficiency.
•
There should be no contact between the chimneys which are placed
side by side.
• There should be no sectional narrowing in any part of the chimney.