Maktec GD0600, Инструкция по эксплуатации, Страница: 6 / 8

6
OPERATION
Turn the tool on without the wheel point making any contact with the workpiece
and wait until the wheel point attains full speed. Then apply the wheel point to
the workpiece gently. To obtain a good finish, move the tool in the leftward
direction slowly.
CAUTION:
• Apply light pressure on the tool. Excessive pressure on the tool will only
cause a poor finish and overloading of the motor.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspec-
tion and replacement, any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Side handle
When using the side handle, remove the rubber protector, insert the side han-
dle on the tool barrel as far as it will go and rotate it to the desired angle. Then
tighten the handle firmly by turning clockwise.
CAUTION:
• When using the tool without handle, always install the rubber protector on the tool.
• When installing the rubber protector, always push it onto the tool until the protrusion inside the rubber fits to the
grooves in the tool.
007056
1. Side handle
1
007054
• Wheel points
• Collet cone set (3 mm, 6 mm, 1/4”, 1/8”)
• Wrench 13
• Side handle set
• Vise holder