Maktec GD0600, Инструкция по эксплуатации, Страница: 5 / 8

5
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see that the switch lever
actuates properly and returns to the “OFF” position when released.
• Do not pull the switch lever forcibly without pushing in the lock-off lever.
For tool with lock button
To prevent the switch lever from accidentally pulled, a lock-off lever is provided.
To start the tool, pull the lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop. For continuous operation, pull
the switch lever and then push in the lock button. To stop the tool from the
locked position, pull the switch lever fully, then release it.
For tool without lock button
To prevent the switch lever from accidentally pulled, a lock-off lever is provided.
To start the tool, pull the lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing wheel point
Loosen the collet nut and insert the wheel point into the collet nut. Use one
wrench to hold the spindle and the other one to tighten the collet nut securely.
The wheel point should not be mounted more than 8 mm from the collet nut.
Exceeding this distance could cause vibration or a broken shaft.
To remove the wheel point, follow the installation procedure in reverse.
CAUTION:
• Use the correct size collet cone for the wheel point which you intend to
use.
1. Switch lever
2. Lock-off lever
3. Lock button
1
2
3
007053
1. Wrench 13
2. Collet nut
3. Wrench 13
1
2
3
007055
8mm(5/16”)Max.
003495