19
5 Operation
2. The height will be adjusted by turning the bolt shown below. Turning it clockwise, the router goes up,
counterclockwise, the router goes down. After the height has been set, tighten the router’s fi xing screws
again.
Scraper Adjustment
If you need to make any adjustments to the scraper system, you can follow the instructions below. Pay
attention to each of the screws, checking how to make the correct adjustment of all.
To make the adjustment fi rst lift the feed assembly to its max height (70 mm).
Note that for the adjustment of screws E, F and G, the RBB.4G comes with a wrench with a specifi c size for
this adjustment.
