6
Test safety systems for possible faulty operation before
pin-nailing as follows.
1. Make sure that the tool is not loaded with pin
nails before the test.
2.
Pull the sliding door of the magazine toward yourself.
1
014777
3.
The tool accidentally operates if only the trigger is
pulled although the lever is not pulled.
4. The tool does not operate when the trigger is
pulled with the lever pulled.
In case of 3 and 4 above, the safety systems are faulty.
Trigger and lever
CAUTION:
•
Before inserting the battery cartridge into the tool, always
check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
1
007728
The tool is provided with lever as a safety system in
addition to the usual trigger.
1
007729
To fire pin-nails, first pull the lever and then pull the trigger.
Adjusting the depth of pin-nailing
WARNING:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before loading the pin nailer.
1
2
007734
Depth of pin-nailing can be adjusted on this pin nailer.
Turn two bolts a quarter turn using the hex wrench
provided with the tool and the driver guide cover will
slide up or down. Depth can be adjusted 1.5 mm to the
maximum. At desired depth, secure it with two bolts
firmly.
Lighting up the lamps
CAUTION:
•
Do not look in the light or see the source of light
directly.
1
2
014778
To turn on the lamp, pull the lever. Release the lever to
turn it off.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
•
Even in the lamp lights up when the battery power
residual gets small, pin nailer may not fire pin nails.
In this case, charge the battery cartridge.
Anti-dry firing device
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before loading the pin nailer.
When the number of remaining pin nails in the
magazine are 0 - 3 pcs., the trigger can no longer be
pulled. At this time, insert a new strip of pin nails in the
magazine and the trigger can be pulled again.
1. Lamp
2. Lever
1. Bolts
2. Driver guide
cover
1. Trigger
1. Lever
1. Sliding door
