![background image](http://html1.mh-extra.com/html/makita/xmt04/xmt04_instruction-manual_4720997006.webp)
6
ENGLISH
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
1
2
►
1.
Indicator lamps
2.
Check button
Press the check button on the battery cartridge to indi
-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Remaining
capacity
Lighted
Off
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE:
The first (far left) indicator lamp will blink when
the battery protection system works.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys
-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto
-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload alert function
The overload alert function may work if the current rises
sharply due to the operation such as applying too much
pressure onto a workpiece.
The overload alert function decline the speed of the oscil-
lation and then increases the amplitude of vibration.
In this case, once isolate the application tool from the
workpiece, then the speed of the oscillation goes back.
Continue operation with an appropriate load.
Overload protection
When the tool/battery is operated in a manner that
causes it to draw an abnormally high current, the tool
stops automatically. In this situation, turn the tool off
and stop the application that caused the tool to become
overloaded. Then turn the tool on to restart.
Overheat protection
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
Protection lock function
When the protection system works repeatedly, the tool is locked.
In this situation, the tool does not start even if turning
the tool off and on. To release the protection lock,
remove the battery, set it to the battery charger and wait
until the charging finishes.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
tool is switched off.
1
►
1.
Slide switch
To start the tool, slide the slide switch toward the “I
(ON)” position.
To stop the tool, slide the slide switch toward the “O
(OFF)” position.
Содержание XMT04
Страница 23: ...23...