13 ENGLISH
1. To install the X-LOCK wheel, make sure that both
catches are in the unlocked position.
If not, push the release lever from A side to lift B
side, then pull the release lever from B side as
illustrated. The catches are set in the unlocked
position.
B
A
1
2
►
1.
Catch
2.
Release lever
2. Place a central position of the X-LOCK wheel on
the holder.
Make sure the X-LOCK wheel is parallel to the
flange surface and with the correct side facing up.
3. Push the X-LOCK wheel into the holder. The
catches snap into the lock position with a click and
fix the X-LOCK wheel.
2
1
4
3
►
1.
X-LOCK wheel
2.
Holder
3.
Flange surface
4.
Catch
4.
Make sure the X-LOCK wheel is fixed correctly.
The surface of the X-LOCK wheel is no higher than
the surface of the holder as shown in the figure.
If not, the holder must be cleaned or the X-LOCK
wheel must not be used.
1
2
►
1.
Surface of the holder
2.
Surface of the X-LOCK wheel
To remove the X-LOCK wheel, push the release lever from A side
to lift B side, then pull the release lever from B side as illustrated.
The X-LOCK wheel is released and can be removed.
B
A
1
►
1.
Release lever
OPERATION
WARNING:
It should never be necessary to force the
tool.
The weight of the tool applies adequate pressure. Forcing
and excessive pressure could cause dangerous wheel breakage.
WARNING:
ALWAYS replace wheel if tool is
dropped while grinding.
WARNING:
NEVER hit the workpiece with the wheel.
WARNING:
Avoid bouncing and snagging the
wheel, especially when working corners, sharp
edges etc.
This can cause loss of control and kickback.
WARNING:
NEVER use tool with wood cutting blades
and other saw blades.
Such blades when used on a grinder fre-
quently kick and cause loss of control leading to personal injury.
WARNING:
Never actuate the release lever of the
X-LOCK holder during operation.
The X-LOCK wheel
comes off from the tool and may cause serious injury.
WARNING:
Make sure that the X-LOCK wheel
is fixed firmly.
