Makita UT001GM102, Инструкция по эксплуатации

Страница: 9 / 16

9 ENGLISH
4. When not in use, store the chuck key as shown in
the figure to keep it from being lost.
1
Fig.10
►
1. Chuck key
Installing the mixing blade
Optional accessory
Insert the mixing blade into the shaft and secure it with
the hex bolt. At this time, position it so that the top end
of the hex bolt always fits to the flat surface on the shaft
and tighten the hex bolt with the provided wrench.
1
2
3
4
Fig.11
►
1. Hex bolt 2. Shaft 3. Flat surface 4. Mixing blade
When installing the mixing blades at two different posi
-
tions, mount and secure the two mixing blades on the
flat part of the shaft with the hex bolts so that the same
surface of the mixing blades faces each other as shown
in the figure.
1
2
3
4
Fig.12
►
1. Hex bolt 2. Shaft 3. Flat surface 4. Mixing blade
NOTE: Ask your local Makita Service Center about
which is mixing blades are allowed.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
CAUTION:
Do not use this tool with the
battery adapter. If you connect the battery adapter
to the tool, the battery cover cannot be closed, and
using the tool with battery cover opened may cause
an injury.
CAUTION:
Be careful not to pinch your fin
-
gers when opening or closing the battery cover.
NOTICE:
Install a battery cover that matches the
size of the battery.
Open the battery cover while pressing the button on the
battery cover.
2 1
Fig.13
►
1. Button 2. Battery cover