7
ENGLISH
Installing the backing pad
1
2
1.
Backing pad
2.
Hex wrench
Put the backing pad on the shaft then turn the bolt
clockwise with a hex wrench.
CAUTION:
Make sure that the backing pad is
secured properly.
Loose attachment will run out of
balance and cause a excessive vibration which may
cause loss of control.
Installing side grip
Optional accessory
1
2
1.
Cap
2.
Side grip
Remove the cap and screw the side grip on the tool
securely.
The side grip can be installed on either side of the tool.
Installing or removing pad
Optional accessory
CAUTION:
Only use hook-and-loop system
pads for polishing.
1
1.
Pad
To install the pad, irst remove all dirt and foreign mat
-
ter from the hook-and-loop system of the pad and the
backing pad. Attach the pad to the backing pad so that
their edges are aligned.
To remove the pad from the backing pad, just pull up
from its edge.
CAUTION:
Make sure that the pad and
backing pad are aligned and securely attached.
Otherwise the pad will cause a excessive vibration
which may cause loss of control or the pad may be
thrown out from the tool.
OPERATION
CAUTION:
Only use Makita genuine pads for
polishing.
CAUTION:
Make sure the work material is
secured and stable. Falling object may cause
personal injury.
CAUTION:
Hold the tool irmly with one hand
on the switch handle and the other hand on the
front grip (or side handle) when performing the
tool.
CAUTION:
Do not run the tool at high load
over an extended time period.
It may result in tool
malfunction which causes electric shock, ire and/or
serious injury.
CAUTION:
Be careful not to touch the rotating
part.
NOTICE:
Never force the tool.
Excessive pressure
may lead to decreased polishing eficiency, damaged
pad, or shorten tool life.
NOTICE:
Continuous operation at high speed
may damage work surface.
