2
ENGLISH
SPECIFICATIONS
Model:
PO5000C
PO6000C
Pad diameter
125 mm
150 mm
Orbits per minute
0 - 6,800 min
-1
Overall length
451 mm
Net weight
2.8 - 3.0 kg
Safety class
/II
•
Due to our continuing program of research and development, the speciications herein are subject to change
without notice.
•
Speciications may differ from country to country.
•
The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Intended use
The tool is intended for polishing.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841:
Model PO5000C
Sound pressure level (L
pA
) : 81 dB(A)
Sound power level (L
WA
) : 92 dB (A)
Uncertainty (K) : 3 dB(A)
Model PO6000C
Sound pressure level (L
pA
) : 83 dB(A)
Sound power level (L
WA
) : 94 dB (A)
Uncertainty (K) : 3 dB(A)
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841:
Model PO5000C
Work mode: polishing
Vibration emission (a
h, P
) : 6.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
Model PO6000C
Work mode: polishing
Vibration emission (a
h, P
) : 7.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
NOTE:
The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE:
The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING:
Read all safety warnings, instruc-
tions, illustrations and speciications provided with this
power tool.
Failure to follow all instructions listed below
may result in electric shock, ire and/or serious injury.
