3
ENGLISH (Original instructions)
Explanation of general view
1-1. Lever
2-1. Wing nut
2-2. Bevel scale plate
3-1. Base plate
3-2. Cutting line
4-1. Lock button / Lock-off button
4-2. Switch trigger
5-1. Shaft lock
5-2. Wrench
6-1. Hex bolt
6-2. Saw blade
6-3. Outer flange
6-4. Inner flange
7-1. Side grip
10-1. Rear handle
10-2. Front grip
10-3. Base
11-1. Wing nut
11-2. Guide rule
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
SPECIFICATIONS
Model N5900B
Blade diameter
235 mm
at 90°
85 mm
at 45°
60 mm
Max. Cutting depth
at 50°
53 mm
No load speed (min
-1
) 4,100
Overall length
380 mm
Net weight
7.2 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE028-1
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
ENF100-1
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavorable
mains conditions can have adverse effects to the operation
of other equipment. With a mains impedance equal or less
than 0.31 Ohms it can be presumed that there will be no
negative effects. The mains socket used for this device
must be protected with a fuse or protective circuit breaker
having slow tripping characteristics.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN60745:
Sound pressure level (L
pA
) : 89 dB (A)
Sound power level (L
WA
) : 100 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
h,W
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Work mode : cutting metal
Vibration emission (a
h,M
) : 2.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
Содержание N5900B
Страница 70: ...70 ...
Страница 71: ...71 ...
Страница 72: ...72 Makita Corporation Anjo Aichi Japan www makita com 884505 967 ...