![background image](http://html.mh-extra.com/html/makita/mt01/mt01_instruction-manual_1722866006.webp)
6 ENGLISH
Press the check button on the battery cartridge to indi
-
cate the remaining battery capacity. The indicator lamps
light up for few seconds.
Indicator lamps
Remaining
capacity
Lighted
Off
75% to 100%
50% to 75%
25% to 50%
0% to 25%
NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
tool is switched off.
1
Fig.3
►
1.
Slide switch
To start the tool, slide the slide switch toward the “I
(ON)” position.
To stop the tool, slide the slide switch toward the “O
(OFF)” position.
Adjusting the orbital stroke rate
1
Fig.4
►
1.
Dial
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 5. The
higher the number is, the higher the orbital stroke
rate is. Preset the dial to the number suitable for your
workpiece.
NOTE:
The dial cannot be turned directly from 1 to 5
or from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the dial
moving it through each intermediate number.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
1
Fig.5
►
1.
Front lamp
Slide the slide switch toward the "I (ON)" position to
light up the front lamp. The lamp keeps on lighting while
the switch is the "I (ON)" position.
The light automatically goes out after pressing the rear
of the slide switch, and then sliding the slide switch
toward the "O (OFF)" position.
Overload protection
When the tool is overloaded and temperature of the tool
or the battery cartridge reaches a certain level, the front
lamp blinks and the tool automatically stops. Remove
a cause of overload, and cool down the tool and the
battery cartridge to restart.