P 2
2
/
25
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-11. Tips on repair of Dust extraction system DX01, DX02
Fig. 69
Fig. 70
•
Hose 30 is not glued on the other parts, and therefore it is possible to remove Hose 30 from Collector base A (DX01)/
B (DX02) and Inner pipe. (
Fig. 69
)
When it is difficult to remove because of the tight contact, peel it with a thin-slotted screwdriver. (
Fig. 69
)
•
Hose 30 is not glued on the other parts, and therefore it is possible to remove Hose 30 from Collector base A (DX01)/
B (DX02) and Inner pipe. (
Fig. 69
)
When it is difficult to remove because of the tight contact, peel it with a thin-slotted screwdriver. (
Fig. 69
)
• When reassembling
Collector base A/B and Inner pipe, keep a right angle between them.
In assembly of housing L to R and shrinkage of Hose 30, while turning the hose 30 counterclockwise, snap the hooks of
Collector base A/ B into the holes of Slide pipe as drawn in
Fig. 70
. (Reverse the step shown in
Fig. 68.
)
• While turning Hose 30 clockwise, adjust your desired positions of Hose, Collector base A/ B and Inner pipe each other.
The inner diameter of the spring of Hose is expanded, and consequently this way allows loose contact of Hose during
revolving.
Collector base A/ B
Hose 30
DISASSEMBLING
ASSEMBLING
