![background image](http://html1.mh-extra.com/html/makita/lxmt02/lxmt02_instruction-manual_4720866007.webp)
7
Indication lamp
1
012771
•
When the remaining battery capacity gets low, the
indication lamp blinks.
•
When the remaining battery capacity gets much
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
At this time, remove the battery cartridge from the tool
and charge it.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
•
Do not install application tool upside down.
Installing application tool upside down may damage
the tool and cause serious personal injury.
•
Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
1
3
2
012826
1
2
3
012767
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction, mount
a sanding paper so that the holes in a sanding paper
match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
1
2
3
4
012847
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
Hex wrench storage
1
012766
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1. Hex wrench
1. Application tool
installation bolt
2. Holes in the
application tool
3. Adapter (required
for some
application tools)
4. Protrusions of
the tool flange
1. Application tool
installation bolt
2. Hex wrench
3. Tighten
1. Application tool
installation bolt
2. Holes in the
application tool
3. Protrusions of
the tool flange
1. Indication lamp