![background image](http://html.mh-extra.com/html/makita/ls1018/ls1018_instruction-manual_232311008.webp)
8
SPECIFICATIONS
Model
LS1018 / LS1018L
Blade diameter
255 mm - 260 mm
Hole diameter
For all countries other than European countries
25.4 mm
For European countries
30 mm
Max. Cutting capacities (H x W) with 260 mm in diameter
Bevel angle
Miter angle
45° (left)
0°
45° (right)
0°
50 mm x 310 mm
91 mm x 310 mm
31 mm x 310 mm
45°
50 mm x 220 mm
91 mm x 220 mm
31 mm x 220 mm
60° (right)
-
91 mm x 153 mm
-
No load speed (min
-1
)
4,300
Laser Type (LS1018L only)
Red Laser 650 nm,
1mW ( Laser Class 2 )
Dimensions (L x W x H)
825 mm x 536 mm x 633 mm
Net weight
For all countries other than European countries………19.8 kg
For European countries…………………………………….…19.9 kg
Safety class
/II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END222-1
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
・
Read instruction manual.
・
DOUBLE
INSULATION
・
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
・
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
・
Do not place hand or fingers close to the
blade.
・
Adjust sliding fences clear of blade and
blade guard properly.
・
Always remove SUB-FENCE R when
performing right bevel cuts. Failure to do
so may cause serious injury to operator.
・
Never look into the laser beam. Direct
laser beam may injure your eyes.
・
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
ENE006-1
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN61029:
Sound pressure level (L
pA
) : 97 dB(A)
Sound power level (L
WA
) : 103 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN61029:
Содержание LS1018
Страница 130: ...130 ...
Страница 131: ...131 ...
Страница 132: ...132 Makita Corporation Anjo Aichi Japan www makita com JM2328A028 ...