1R207 : 45 degrees set square
1R208 : 90 degrees set square
[16] Angle adjustment of saw blade
1. Adjust the angle of saw blade at 90° against turn base using 90 degrees set square (Makita Part No.1R208). See
Fig. 15-1
.
While keeping this condition, fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm. See
Fig. 15-2
.
2. As for 45° degrees adjusting, use 45 degrees set square as Fig.
15-3
.
After that the fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm as
Fig. 15-4.
Fig. 15-1
Fig. 15-3
45°
90°
Fig. 15-2
Fig. 15-4
Arm
Arm
0 degrees bevel angle adjusting bolt
(Hex bolt M6x16)
45 degrees bevel angle adjusting bolt
(Hex bolt M6x16)
45°
90°
[17] Adjustment for max. cutting capacity
Do the following steps to obtain the max. cutting capacity.
1. Pull the motor unit to your side until it stops.
2. Lower the motor unit until it stops.
3. And then adjust the
Ø
190mm saw blade so that it comes to the position shown in
Fig. 16
.
Note: The saw blade must not contact kerf boards and base, when the motor unit is in the lowest position
.
4. Tighten hex bolt M6x16 using socket wrench 10.
ø190mm saw blade
Fig. 16
Hex bolt M6x16
Socket wrench 10
(Standard equipment)
Kerf board
R
epair
P 1
3
/ 2
6
